2
www.amcelettronica.com
KX series v.1.70
IMPORTANT NOTES
• The following manual has been prepared to provide assistance to users who use the system. All those who
use the systems listed in this manual must be authorized.
• The information contained in this document are property of AMC Elettronica s.r.l.
• All information contained in this document is subject to change without notice.
• Every part of this manual should be interpreted and used only for the purposes for which it was drafted, the
use other than as prescribed must be authorized by AMC Elettronica srl, under penalty of forfeiture of the
guarantee.
• All trademarks, symbols and examples contained in this manual belong to their respective owners.
GUARANTEE
AMC Electronics s.r.l. ensures that products are free from defects in workmanship.
The product is not installed by the manufacturer and can be used with other products not manufactured by AMC
Elettronica srl, the manufacturer does not guarantee or be held responsible for damage and / or theft or other
types of issues caused by an incorrect installation and / or configuration of the system.
Is not guaranteed to:
- improper use of the panel
- programming errors
- manipulation and vandalism
- wear and tear
- lightning, floods, fire.
AMC Electronics s.r.l. reserves the right to repair or replace the defective product within the limits established
for 24 months.
A different use from that stated in this manual will void the warranty.
The installation must be performed in a workmanlike manner by qualified personnel.
COMPLIANCE
AMC Electronics s.r.l. declares that the X and K series alarm control unit are provisions of Directive 1999/5 /CE
On our web site www.amcelettronica.com
STANDARDS:EN 50136-1 + EN 50136-2 ( GSM and PSTN alarm transmission)
All products mentioned in this manual are in accordance with the rules:
EN 50131-1 + EN 50131-3 + EN 50131-6 (control and indicating equioment for alarm system)
EN 50136-1 + EN 50136-2 ( GSM and PSTN alarm transmission)
Certifier: IMQ – Sistemi di sicurezza Grade: 2 Class:2
Following is the list of normed products:
K4P: control unit (plastic box)
K8P: control unit (plastic box)
K8plusP: control unit (plastic box)
X412P: control unit (plastic box)
X824P: control unit (plastic box)
X864P: control unit (plastic box)
K4M: control unit (plastic box)
K8M: control unit (plastic box)
K8plusM: control unit (Metal box)
X412M: control unit (Metal box)
X824M: control unit (Metal box)
X864M: control unit (Metal box)
PSTN carrier ATS type B on board K4 e K8 (ATS2: D2-M2-T2-S0-I0)*
KLCD: keypad
KLight: keypad
KLight plus: keypad with 2 in/out terminal
KXIN: inputs expansion
KXOUT: outputs
Transformer 25VA
Transformer 30VA
Xgprs/gsm: gsm - gprs module
IP1: IP module
* D2:transmission time 60sec. M2:max transmission time 120sec. T2:time of control information transmission 25h
- S0:no bearing replacement I0: no protection of the information.
To Next Page
Loading...
Need help?
General