6-28
Optional Accessories
6
Duplex Unit
5
Connect the interface cables except for the USB cable, and
connect the power cord.
6
Plug the power plug into the AC power outlet.
7
Connect the USB cable.
NOTE
After installing the duplex unit, you have to specify the settings for the optional
accessories in the [Configuration]/[Device Settings] sheet in the printer driver. You
can obtain the status of the optional accessories automatically by clicking [Get
Device Status] in the [Configuration]/[Device Settings] sheet.
Removing the Duplex Unit
Remove the duplex unit using the following procedure. Have ready the duplex unit
cover removed from the printer when the duplex unit was installed.
WARNING
Be sure to turn the printer and computer OFF, unplug the power plug, and then
disconnect all the interface cables and power cord from the printer before
removing the duplex unit. Otherwise, the power cord or interface cables may be
damaged, resulting in a fire or electrical shock.
IMPORTANT
When moving or servicing the printer, remove the duplex unit.
To Next Page
Loading...
Need help?
General
