exit
address-family ipv4 unicast
route-policy pass-all in
route-policy pass-all out
The following is a part of the configuration from the BGP speaker 192 .168 .200.205 from autonomous system
701 in the same example. Neighbor 171.16 .232.56 is configured as a normal eBGP speaker from autonomous
system 666. The internal division of the autonomous system into multiple autonomous systems is not known
to the peers external to the confederation.
router bgp 701
address-family ipv4 unicast
neighbor 172.16.232.56
remote-as 666
exit
address-family ipv4 unicast
route-policy pass-all in
route-policy pass-all out
exit
address-family ipv4 unicast
neighbor 192.168.200.205
remote-as 701
BGP Route Reflector: Example
The following example shows how to use an address family to configure internal BGP peer 10.1.1.1 as a route
reflector client for both unicast and multicast prefixes:
router bgp 140
address-family ipv4 unicast
neighbor 10.1.1.1
remote-as 140
address-family ipv4 unicast
route-reflector-client
exit
address-family ipv4 multicast
route-reflector-client
BGP Nonstop Routing Configuration: Example
The following example shows how to enable BGP NSR:
configure
router bgp 120
nsr
end
The following example shows how to disable BGP NSR:
configure
router bgp 120
no nsr
end
Cisco ASR 9000 Series Aggregation Services Router Routing Configuration Guide, Release 5.1.x
OL-30423-03 163
Implementing BGP
BGP Route Reflector: Example
To Next Page
Loading...
Need help?
General
