EasyManuals Logo
Home>Cisco>Network Router>A9K-SIP-700

Cisco A9K-SIP-700 Configuration Guide

Cisco A9K-SIP-700
604 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #271 background imageLoading...
Page #271 background image
VRF Configuration Mode
The following example shows how to enter VRF configuration mode:
RP/0/RSP0/CPU0:router# configuration
RP/0/RSP0/CPU0:router(config)# router eigrp 100
RP/0/RSP0/CPU0:router(config-eigrp)# vrf customer1
RP/0/RSP0/CPU0:router(config-eigrp-vrf)#
IPv4 Address Family Configuration Mode
The following example shows how to enter IPv4 address family configuration mode:
RP/0/RSP0/CPU0:router# configuration
RP/0/RSP0/CPU0:router(config)# router eigrp 100
RP/0/RSP0/CPU0:router(config-eigrp)# address-family ipv4
RP/0/RSP0/CPU0:router(config-eigrp-af)#
IPv4 VRF Address Family Configuration Mode
The following example shows how to enter IPv4 VRF address family configuration mode:
RP/0/RSP0/CPU0:router# configuration
RP/0/RSP0/CPU0:router(config)# router eigrp 100
RP/0/RSP0/CPU0:router(config-eigrp)# vrf customer1
RP/0/RSP0/CPU0:router(config-eigrp-vrf)# address-family ipv4
RP/0/RSP0/CPU0:router(config-eigrp-vrf-af)#
Interface Configuration Mode
The following example shows how to enter interface configuration mode in IPv4 address family configuration
mode:
RP/0/RSP0/CPU0:router# configuration
RP/0/RSP0/CPU0:router(config)# router eigrp 100
RP/0/RSP0/CPU0:router(config-eigrp)# address-family ipv4
RP/0/RSP0/CPU0:router(config-eigrp-af)# interface GigabitEthernet 0/3/0/0
RP/0/RSP0/CPU0:router(config-eigrp-af-if)#
EIGRP Interfaces
EIGRP interfaces can be configured as either of the following types:
• Active—Advertises connected prefixes and forms adjacencies. This is the default type for interfaces.
• Passive—Advertises connected prefixes but does not form adjacencies. The passive command is used
to configure interfaces as passive. Passive interfaces should be used sparingly for important prefixes,
such as loopback addresses, that need to be injected into the EIGRP domain. If many connected prefixes
need to be advertised, then the redistribution of connected routes with the appropriate policy should be
used instead.
Cisco ASR 9000 Series Aggregation Services Router Routing Configuration Guide, Release 5.1.x
OL-30423-03 243
Implementing EIGRP
EIGRP Interfaces

Table of Contents

Other manuals for Cisco A9K-SIP-700

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco A9K-SIP-700 and is the answer not in the manual?

Cisco A9K-SIP-700 Specifications

General IconGeneral
BrandCisco
ModelA9K-SIP-700
CategoryNetwork Router
LanguageEnglish

Related product manuals