Enabling RCC and LCC: Example
Enabling RCC and LCC Background Scan: Example
This example shows how to enable Route Consistency Checker (RCC) background scan with a period of 500
milliseconds between buffers in scans for IPv6 unicast tables:
rcc ipv6 unicast period 500
This example shows how to enable Label Consistency Checker (LCC) background scan with a period of 500
milliseconds between buffers in scans for IPv6 unicast tables:
lcc ipv6 unicast period 500
Enabling RCC and LCC On-demand Scan: Example
This example shows how to run Route Consistency Checker (RCC) on-demand scan for subnet 10.10.0.0/16
in vrf1:
show rcc ipv4 unicast 10.10.0.0/16 vrf vrf 1
This example shows how to run Label Consistency Checker (LCC) on-demand scan on all labels for IPv6
prefixes:
show lcc ipv6 unicast all
Where to Go Next
For additional information on the protocols that interact with RIB, you may want to see the following
publications:
•
Implementing MPLS Layer 3 VPNs in Cisco ASR 9000 Series Aggregation Services Router MPLS
Configuration Guide
•
Implementing BGP in Cisco ASR 9000 Series Aggregation Services Router Routing Configuration
Guide
•
Implementing EIGRP in Cisco ASR 9000 Series Aggregation Services Router Routing Configuration
Guide
•
Implementing IS-IS in Cisco ASR 9000 Series Aggregation Services Router Routing Configuration
Guide
•
Implementing OSPF in Cisco ASR 9000 Series Aggregation Services Router Routing Configuration
Guide
•
Implementing RIP in Cisco ASR 9000 Series Aggregation Services Router Routing Configuration Guide
•
RIB Commands in Cisco ASR 9000 Series Aggregation Services Router Routing Command Reference
Cisco ASR 9000 Series Aggregation Services Router Routing Configuration Guide, Release 5.1.x
OL-30423-03 439
Implementing and Monitoring RIB
Enabling RCC and LCC: Example
To Next Page
Loading...
Need help?
General
