Cisco A9K-SIP-700 Configuration Guide

PurposeCommand or Action
Enables IPv6 checksum support on the interface.
To disable, use the disable keyword.
ipv6 checksum [disable]
Example:
RP/0/RSP0/CPU0:router(config-bfd-if)# ipv6
checksum disable
Step 3
commit
Step 4
Enabling and Disabling IPv6 Checksum Calculations for BFD on an Individual Interface or
Bundle
The following procedures describe how to enable or disable IPv6 checksum calculations on an interface or
bundle .
DETAILED STEPS
SUMMARY STEPS
1.
configure
2.
bfd
3.
interface type interface-path-id
4.
ipv6 checksum [disable]
5.
commit
DETAILED STEPS
PurposeCommand or Action
configure
Step 1
Enters BFD configuration mode.bfd
Example:
RP/0/RSP0/CPU0:router(config)# bfd
Step 2
Enters BFD interface configuration mode for a
specific interface or bundle.
interface type interface-path-id
Example:
RP/0/RSP0/CPU0:router(config-bfd)# interface
gigabitEthernet 0/1/5/0
Step 3
Cisco ASR 9000 Series Aggregation Services Router Routing Configuration Guide, Release 5.1.x
OL-30423-03 217
Implementing BFD
Enabling and Disabling IPv6 Checksum Support

Cisco A9K-SIP-700 Specifications

General

Brand	Cisco
Model	A9K-SIP-700
Category	Network Router
Language	English