PurposeCommand or Action
(Optional) Specifies a cost for the default summary route
sent into a stub area or an NSSA.
default-cost cost
Example:
RP/0/RSP0/CPU0:router(config-ospf-ar)#default-cost
15
Step 7
•
Use this command only on ABRs attached to the NSSA.
Do not use it on any other routers in the area.
•
The default cost is 1.
commit
Step 8
—
Repeat this task on all other routers in the stub area or NSSA.
Step 9
Configuring Neighbors for Nonbroadcast Networks
This task explains how to configure neighbors for a nonbroadcast network. This task is optional.
Before You Begin
Configuring NBMA networks as either broadcast or nonbroadcast assumes that there are virtual circuits from
every router to every router or fully meshed network.
Cisco ASR 9000 Series Aggregation Services Router Routing Configuration Guide, Release 5.1.x
362 OL-30423-03
Implementing OSPF
Configuring Neighbors for Nonbroadcast Networks
To Next Page
Loading...
Need help?
General
