BGP main routing table version 1
BGP scan interval 60 secs
BGP is operating in STANDALONE mode.
Process RecvTblVer bRIB/RIB SendTblVer
Speaker 1 1 1
Some configured eBGP neighbors do not have both inbound and
outbound policies configured for IPv4 Multicast address family.
These neighbors will default to sending and/or receiving no
routes and are marked with ’!’ in the output below. Use the
’show bgp neighbor <nbr_address>’ command for details.
Neighbor Spk AS MsgRcvd MsgSent TblVer InQ OutQ Up/Down St/PfxRcd
10.0.101.2 0 2 0 0 0 0 0 00:00:00 Idle!
Address Family: IPv6 Unicast
============================
BGP router identifier 10.0.0.1, local AS number 1
BGP generic scan interval 60 secs
BGP main routing table version 2
BGP scan interval 60 secs
BGP is operating in STANDALONE mode.
Process RecvTblVer bRIB/RIB SendTblVer
Speaker 2 2 2
Neighbor Spk AS MsgRcvd MsgSent TblVer InQ OutQ Up/Down St/PfxRcd
2222::2 0 2 920 918 2 0 0 15:15:11 1
2222::4 0 3 0 0 0 0 0 00:00:00 Idle
Address Family: IPv6 Multicast
==============================
BGP router identifier 10.0.0.1, local AS number 1
BGP generic scan interval 60 secs
BGP main routing table version 1
BGP scan interval 60 secs
BGP is operating in STANDALONE mode.
Process RecvTblVer bRIB/RIB SendTblVer
Speaker 1 1 1
Some configured eBGP neighbors do not have both inbound and
outbound policies configured for IPv6 Multicast address family.
These neighbors will default to sending and/or receiving no
routes and are marked with ’!’ in the output below. Use the
’show bgp neighbor <nbr_address>’ command for details.
Neighbor Spk AS MsgRcvd MsgSent TblVer InQ OutQ Up/Down St/PfxRcd
2222::2 0 2 920 918 0 0 0 15:15:11 0
2222::4 0 3 0 0 0 0 0 00:00:00 Idle!
Table Policy
The table policy feature in BGP allows you to configure traffic index values on routes as they are installed in
the global routing table. This feature is enabled using the table-policy command and supports the BGP policy
accounting feature.
BGP policy accounting uses traffic indices that are set on BGP routes to track various counters. See the
Implementing Routing Policy on Cisco ASR 9000 Series Router module in the Cisco ASR 9000 Series
Aggregation Services Router Routing Configuration Guide for details on table policy use. See the Cisco
Cisco ASR 9000 Series Aggregation Services Router Routing Configuration Guide, Release 5.1.x
32 OL-30423-03
Implementing BGP
Table Policy
To Next Page
Loading...
Need help?
General
