For information on IS-IS support for Bidirectional Forwarding Detection (BFD), see Cisco ASR 9000
Series Aggregation Services Router Interface and Hardware Component Configuration Guide and
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command
Reference.
Note
IS-IS Configuration Grouping
Cisco IOS XR groups all of the IS-IS configuration in router IS-IS configuration mode, including the portion
of the interface configurations associated with IS-IS. To display the IS-IS configuration in its entirety, use
the show running router isis command. The command output displays the running configuration for all
configured IS-IS instances, including the interface assignments and interface attributes.
IS-IS Configuration Modes
The following sections show how to enter each of the configuration modes. From a mode, you can enter the
? command to display the commands available in that mode.
Router Configuration Mode
The following example shows how to enter router configuration mode:
RP/0/RSP0/CPU0:router# configuration
RP/0/RSP0/CPU0:router(config)# router isis isp
RP/0/RSP0/CPU0:router(config-isis)#
Router Address Family Configuration Mode
The following example shows how to enter router address family configuration mode:
RP/0/RSP0/CPU0:router(config)# router isis isp
RP/0/RSP0/CPU0:router(config-isis)# address-family
ipv4 u
nicast
RP/0/RSP0/CPU0:router(config-isis-af)#
Interface Configuration Mode
The following example shows how to enter interface configuration mode:
RP/0/RSP0/CPU0:router(config)# router isis isp
RP/0/RSP0/CPU0:router(config-isis)# interface GigabitEthernet 0
/3/0/0
RP/0/RSP0/CPU0:router(config-isis-if)#
Cisco ASR 9000 Series Aggregation Services Router Routing Configuration Guide, Release 5.1.x
OL-30423-03 275
Implementing IS-IS
IS-IS Configuration Grouping
To Next Page
Loading...
Need help?
General
