Cisco ASR 5500 Installation Guide

The packaging sequence is as follows:
Step 1
Place the card inside the ESD bag; fold over and seal the bag with an ESD Label or invisible tape as shown in the figure
below.
Step 2
Place the card in the carton as shown in the figure below.
Step 3
Place the top piece of foam over the card.
Step 4
Close the carton and seal it with shipping tape. See Sealing the Shipment, on page 172.
Step 5
Place the shipping label on the outside of the carton. See Labeling the Shipment, on page 172.
Figure 38: Font Card Packaging
Rear Cards
The packing instructions in this section apply to the following cards:
•
Management Input/Output (MIO) or Management Input/Output Universal (UMIO) card
•
Data Processing Card (DPC) or Data Processing Universal (UDPC)
•
Data Processing Card v2 (DPC2) or Data Processing Universal v2 (UDPC2)
Rear cards use the larger ESD bags and shipping cartons. There are very slight differences in the cutouts
at the rear of the MIO/UMIO, DPC/DPC2 or UDPC/UDPC2 foam.
Important
ASR 5500 Installation Guide
174
RMA Shipping Procedures
Rear Cards

Cisco ASR 5500 Specifications

General

Brand	Cisco
Model	ASR 5500
Category	Network Router
Language	English