Cisco ASR 5500 Installation Guide

Step 13
A circuit card will automatically initiate a Power On Self Test (POST) upon insertion into the backplane. If the POST
is successfully completed, the card will reload (reboot) itself. Refer to the Verifying System Startup section in the System
Power-up chapter for additional information.
Step 14
From the CLI run the Exec mode filesystem synchronize all command.
Step 15
Back up the system configuration. Refer to Backing Up the System Configuration, on page 140.
Step 16
For additional instructions, refer to Returning Failed Components, on page 147.
Figure 30: Circuit Card Replacement
Phillips #2 Screw2Circuit card1
Ejector subhandle4Ejector handle3
Swapping the SDHC Memory Card
The SDHC memory card on the MIO/UMIO appears as the /flash drive on the CLI. The /flash drive stores
configuration data, including the boot priority settings.
ASR 5500 Installation Guide
144
Replaceable Components
Replacing a Failed Card

Cisco ASR 5500 Specifications

General

Brand	Cisco
Model	ASR 5500
Category	Network Router
Language	English