Cisco ASR 5500 Installation Guide

Step 7
Push both ejector handles inward firmly until the card is seated in the chassis midplane and you cannot push the ejector
handles in any further. Press firmly on the card's faceplate to ensure that it is fully seated. The card's front panel should
be flush against the chassis' upper and lower card mounts for the slot.
Step 8
Raise the blue subhandle under the top ejector handle to engage the interlock switch. The subhandle also locks the top
ejector handle to the front panel.
Step 9
To secure the card to the chassis, use a Phillips #2 screwdriver to tighten the captive screws within the top and bottom
ejector handles.
Step 10
Repeat step 1 through step 7 for every card you are installing at the rear and front of the chassis.
Baffles
To ensure proper ventilation, baffles must be used in any chassis slot that is not occupied by a circuit card.Caution
ASR 5500 Installation Guide
55
Card Installation
Baffles

Cisco ASR 5500 Specifications

General

Brand	Cisco
Model	ASR 5500
Category	Network Router
Language	English