xStack® DES-3200 Series Layer 2 Managed Fast Ethernet Switch
221
Host Name
Enter an alphanumeric string of no more than 32 characters to identify the remote
SSH user. This parameter is only used in conjunction with the Host Based choice in
Host IP
Enter the corresponding IP address of the SSH user. This parameter is only used in
conjunction with the Host Based choice in the Authentication Method field.
Click the Edit button to re-configure the specific entry.
Click the Apply button to accept the changes made.
NOTE: To set the SSH User Authentication Mode parameters on the Switch, a User Account must be
previously configured.
Trusted Host Settings
Up to ten trusted host secure IP addresses or ranges may be configured and used for remote Switch management.
It should be noted that if one or more trusted hosts are enabled, the Switch will immediately accept remote
instructions from only the specified IP address or addresses. If you enable this feature, be sure to first enter the IP
address of the station you are currently using.
To view this window, click Security > Trusted Host Settings as shown below:
Figure 8-63 Trusted Host window
When the user clicks the Edit button, one will be able to edit the service allowed to the selected host.
The fields that can be configured are described below:
Parameter Description
Enter an IPv4 address to add to the trusted host list.
Enter a Net Mask address to add to the trusted host list.
Tick the check boxes to select services that will be allowed to the trusted host.
Click the Add button to add a new entry based on the information entered.
To Next Page
Loading...
Need help?
General
