xStack
®
DGS-3426G Layer 2 Gigabit Ethernet Managed Switch
103
Configuration Backup/Restore
This window is used to upgrade configuration files from the Commander Switch to the Member Switch. Member Switches will
be listed in the table and will be specified by Port (port on the CS where the MS resides), MAC Address, Model Name and
Version. To specify a certain Switch for upgrading configuration files, click its corresponding radio button under the Port heading.
To update the configuration file, enter the Server IP Address where the firmware resides and enter the Path/Filename of the
firmware. Click Download to initiate the file transfer.
Figure 2 - 117 Configuration File Backup/Restore window
Upload Log
The following window is used to upload log files from SIM member switches to a specified PC. To upload a log file, enter the IP
address of the SIM member switch and then enter the path on your PC to which to save this file. Click Upload to initiate the file
transfer.
To view this window, click Single IP Management > Upload Log File, as shown below:
Figure 2 - 118 Upload Log File window
To Next Page
Loading...
Need help?
General
