Configuration: Premium Feature—Snapshot Virtual Disks 157
The
Specify Virtual Disk Parameters
window is displayed.
9
In the
Snapshot virtual disk parameters
area, select the relevant mapping
option, you can select:
•
Automatic
•
Map later
10
In the
Snapshot repository virtual disk parameters
area, enter the system
behavior when:
• The snapshot repository virtual disk is full to the selected
percentage level.
• The snapshot repository virtual disk is full.
11
Click
Next
.
The
Preview
window containing the summary of the snapshot virtual disk
is displayed.
12
Click
Finish
.
The
Completed
window is displayed.
13
Click
OK
.
14
In the
Mappings
tab, assign mappings between the snapshot virtual disk
and the host that accesses the snapshot virtual disk.
15
To register the snapshot virtual disk with the host operating system, run
the host-based hot_add utility.
16
To associate the mapping between the storage array name and the virtual
disk name, run the host-based SMdevices utility.
Specifying Snapshot Virtual Disk Names
Choose a name that helps you associate the snapshot virtual disk and
snapshot repository virtual disk with its corresponding source virtual disk. The
following information is useful when naming virtual disks:
By default, the snapshot name is shown in the Snapshot virtual disk name
field as:
<source-virtual disk-name>—<sequence-number>
book.book Page 157 Friday, September 23, 2011 2:46 PM
To Next Page
Loading...
Need help?
General
Weight and Dimensions
