Dell POWERVAULT MD3600F User Manual

Management: Installing Array Components 265
Installing the Backplane
1 Align the holes on the backplane with the holes on the array.
2 Tighten the captive screw to secure the backplane to the chassis. See
Figure 16-16 for PowerVault MD3600f or Figure 16-17 for
PowerVault MD3620f.
3 Replace the screws that secure the backplane to the chassis. See
Figure 16-16 for PowerVault MD3600f or Figure 16-17 for
PowerVault MD3620f.
4 Align the slots on the RAID controller module/power supply cage with the
tabs on the chassis. See Figure 16-15.
5 Push the RAID controller module/power supply cage toward the front of
the array.
6 Replace the screws that secure the RAID controller module/power supply
cage to the chassis.
7 Replace the control panel. See "Installing the Control Panel" on page 261.
8 Replace the power supply/cooling fan modules. See "Installing a Power
Supply/Cooling Fan Module" on page 258.
9 Replace the hard drives. See "Installing a Hard Drive" on page 246.
10 Connect all the cables to the array.
11 Turn on the array and the host server.
book.book Page 265 Friday, September 23, 2011 2:46 PM

Dell POWERVAULT MD3600F Specifications

General

HDD speed	15000 RPM
RAID levels	0, 1, 5, 6, 10
Data transfer rate	8 Gbit/s
Storage drive size	3.5 \
Storage drive capacity	600 GB
Storage drive interface	Serial Attached SCSI (SAS)
Storage drives installed	Yes
Installed storage drive type	HDD
Supported storage drive types	HDD & SSD
Total installed storage capacity	3.6 TB
Maximum supported storage capacity	36 TB
Number of storage drives installed	6
Number of storage drives supported	12
Chassis type	-
Product color	Gray
LED indicators	Power, Status
AC input voltage	90-264 V
AC input frequency	47/63 Hz
Number of power supply units	1
Power supply unit (PSU) capacity	600 W
Operating altitude	-16 - 3048 m
Operating temperature (T-T)	10 - 35 °C
Operating relative humidity (H-H)	20 - 80 %

Weight and Dimensions

Depth	561 mm
Width	446.3 mm
Height	86.8 mm
Weight	29300 g