Digi XBee3 802.15.4 User Manual

AT commands Coordinator/End Device configuration commands
Digi XBee3® 802.15.4 RF Module User Guide
86
Bit field:
Bit Meaning Setting Description
0 Allow PanId
reassignment
0 Only associates with Coordinator operating on PAN ID that
matches device ID.
1 May associate with Coordinator operating on any PAN ID.
1 Allow Channel
reassignment
0
Only associates with Coordinator operating on matching CH
channel setting.
1 May associate with Coordinator operating on any channel.
2
Auto Associate
0 Device will not attempt association.
1 Device attempts association until success.
3 Poll coordinator on pin
wake
0 Pin Wake does not poll the Coordinator for indirect (pending)
data.
1 Pin Wake sends Poll Request to Coordinator to extract any
pending data.
4 -
7
Reserved
Default
0
A2 (Coordinator Association)
Sets or displays the Coordinator association options. These options are only applicable when
configured as a coordinator by setting CE command to 1.
Parameter range
0 - 7 (bit field)
Bit field:
Bit Meaning Setting Description
0 Allow Pan ID
reassignment
0 Coordinator will not perform Active Scan to locate available PAN ID. It
operates on ID (PAN ID).
1
Coordinator performs an Active Scan to determine an available ID
(PAN ID). If a PAN ID conflict is found, the ID parameter will change.
1 Allow
Channel
reassignment
0
Coordinator will not perform Energy Scan to determine free channel.
It operates on the channel determined by the CH parameter.
1
Coordinator performs an Energy Scan to find the quietest channel out
of the channels to be scanned determined by the SC parameter. The
Coordinator then operates on that channel.

Digi XBee3 802.15.4 Specifications

General

Brand	Digi
Model	XBee3 802.15.4
Category	Control Unit
Language	English