Servicing the System with Furniture
This chapter describes how to remove the E-35A from the furniture to access internal components for service.
For the assembly instruction on the Fiery NX Station, see the documentation provided with Fiery NX Station kit.
Procedures
If the E-35A is installed in the optional furniture, you need to remove it from the furniture before performing most
service procedures.
Figure 1: E-35A installed on the furniture
To remove the E-35A from the furniture
1 Make sure the E-35A is powered off and all the cables are removed from the back of the E-35A.
To avoid injury, do not lift the E-35A without assistance.
To Next Page
Loading...
Need help?
General
