26 Installation and Service Guide
Installing Hardware
Enabling the power synchronization
During the installation, enable the power synchronization feature by using the OFF/ON switch on the printer interface
board, and the USB power cable included in the accessory kit. The default switch position is OFF.
When you enable power synchronization, the E-35A synchronizes power with the printer’s main power off/on status.
If the printer powers off, the E-35A receives signals from the printer through the USB cable connected to the printer
interface board, and automatically starts the shutdown process. If the E-35A receives the startup signals from the
printer, the E-35A automatically powers on and begins the startup sequence.
To enable the power synchronization feature at the E-35A
1 Shut down the E-35A (see page 43) and the printer.
2 Remove the port cover that is attached to the Type B USB port on the printer interface board.
3 Locate the USB cable in the accessory kit that comes with the E-35A.
4 Connect one end of the USB cable (Type B) to the port on the printer interface board of the E-35A. Connect the
other end of the cable (Type A) to the USB port on the printer.
Important: After the power synchronization is enabled, make sure to control the E-35A power using the printer.
To Next Page
Loading...
