41 Installation and Service Guide
Using the E-35A
Network status LEDs
Two LEDs next to the network connector indicate the network link status and speed. For additional information about
network setup, see Configuration and Setup, which is part of the user documentation set.
Figure 18: Ethernet network port (upper RJ-45)
Table 1: Network link indicators
Table 2: Network speed indicators
Starting, shutting down, restarting, and rebooting
Generally, you can leave the E-35A and the printer running all the time. Restarting the E-35A resets the E-35A system
software, but does not reboot the entire system. Network access to the E-35A is temporarily interrupted and all
currently processing jobs are terminated.
1LINK/ACTIVITY
2 SPEED
LINK/ACTIVITY LED Network link status
Off No link to network
Solid green Valid link to network
Flashing green Data transfer is in progress
SPEED LED Network speed
Off 10 Megabits/second
Solid green 100 Megabits/second
Flashing green 1000 Megabits/second
Important: Unless instructed otherwise by a troubleshooting procedure, always shut down the E-35A from the
Fiery QuickTouch display. Do not use the power button on the side to shut down the E-35A.
To Next Page
Loading...
Need help?
General
