FlexRadio FLEX-6000 Signature Series User Manual

FLEX-6000 Signature Series – Maestro User Guide
Page 121
Copyright 2019 FlexRadio Systems. All Rights Reserved.
28.3 DIGI MODE AUDIO OFFSETS
When operating the radio in DIGU or DIGL mode a receive filter Offset control is available in the Slice
Receiver Menu. This control allows the operator to set the audio offset in Hertz of the center of the
receiver’s bandpass preset filters. When Tap Tuning a Slice Receiver with an Offset set to a non-zero
value, the Slice Receiver’s frequency will be adjusted so that the center of the receiver’s bandpass
filter will be tuned to the frequency that was Tap Tuned. The default offset for DIGU is 1500Hz and
the default for DIGL is 2210 Hz.
This feature allows the operator to configure a narrow filter in DIGU or DIGL mode, then conveniently
drop it over a signal of interest by simply double tapping on the signal.

FlexRadio FLEX-6000 Signature Series Specifications

General

Brand	FlexRadio
Model	FLEX-6000 Signature Series
Category	Control Unit
Language	English