FLEX-6000 Signature Series – Maestro User Guide
Page 32
Copyright 2019 FlexRadio Systems. All Rights Reserved.
When the radio is registered, the screen will update to indicate the registered status as shown below.
The final configuration step is to map communication ports in the radio to the outside world. Open
the Network Settings pane as shown above and select Automatic mode. Tap the Test button. If the
indicator turns green, SmartLink configuration for your radio is complete.
Automatic mode should work for most networks. If it doesn’t, it may be necessary to enable UPnP
(Universal Plug n Play) in your in your router or to manually configure port forwarding, also in your
router. Refer to the following HelpDesk article for more information:
https://helpdesk.flexradio.com/hc/en-us/articles/115003365503-What-is-Port-Forwarding-and-
How-do-you-do-it
7.2.3 Test the Radio in SmartLink
Referring to the figure above, open the Network Settings pane and tap the Test button. SmartLink
will send a request to the online SmartLink server to test the connection to the radio using the
information configured in section 7.2.2. If the SmartLink configuration is correct, the indicator next
to the Test button will turn green. Tapping the indicator will reveal configuration information about
the SmartLink connection.
To Next Page
Loading...
Need help?
General
