FlexRadio FLEX-6000 Signature Series User Manual

FLEX-6000 Signature Series – Maestro User Guide
Page 139
Copyright 2019 FlexRadio Systems. All Rights Reserved.
o Bandwidth from 400 to 1000 Hz: Level 2
o Bandwidth from 1000 to 1500 Hz: Level 1
o Bandwidth from 1500 to 10000 Hz: Level 0
• USB/LSB/AM/SAM
o Level 3 for all bandwidths
• FM/NFM/DFM
o Level 0 for all bandwidths
All TX filtering is performed with low latency (less sharp) filters.
30.9 XVTR TAB
The XVTR Tab allows the user to set up transverter bands for the FLEX-6000. Tapping the Add button
creates a new tab for a new transverter band definition. Refer to the section 24, How to Configure
Transverters for detailed information on configuring transverters.
30.10 PROFILES TAB
The Profiles tab loads, saves and deletes global, transmit and microphone profiles. See section 14,
How to Use Profiles, for full details.
30.11 MEMORY TAB
The Memory tab loads, adds and deletes sets of radio configuration information for rapid recall. See
section 19.2, Memory Channels for full details. While section 19.2 describes the use of Memories
with the FM modes, Memories can be used with any mode.
30.12 SPOTS TAB
The Spots tab is described in section 23, Displaying Spots in SmartSDR for Maestro.
30.13 USB CABLES TAB
The USB Cables tab is described in detail in section 27.1, USB Cables Overview.

FlexRadio FLEX-6000 Signature Series Specifications

General

Brand	FlexRadio
Model	FLEX-6000 Signature Series
Category	Control Unit
Language	English