·SPECIFICATIONS-------------
LUBRICANTS
Engine
Ford
M2C121-E
Where
all
the above mentioned oils cannot
be
used, the chosen oil must,
at
minimum, meet
A.P.I. (American Petroleum Institute) quality
level ..
CD"
- U.S.A. Military specification -
MIL-L-2104C
or
preferably, A.P.I. quality
"SF/CD"
- U.S.A. Military specification
MIL-L-2104D.
Choose
the
correct
viscosity
grade
from the chart
on
the right.
NOTE:
In
areas
where prolonged periods of
extreme temperatures are
encountered,
local
lubricant practices are acceptable; such
as
the
use
of SAE
5W
in
extreme
low
temperatures
or
SAE 50 in
extreme
high
temperatures.
The
engine
oU
change
period is
shown
on page 13
of Section
B.
However,
locally available fuel
may
have
a high sulfur content,
in
which case
the
oil
change period should be adjusted
as
follows:-
Hydrostatic Steering Reservoir
Belt Pulley
Four
Wheel Drive Differential
Casing and Front Hubs
Front Wheel Bearings (2wd)
and
Lubrication Fittings
Constant Mesh Transmission (8 x 2)
Slmttle Shift Transmission (8 x 8
or
16 x 8)
Rear
Axle
FOUR
WHEEL
DRIVE
AU
models
Sulfur
Content
% OU
Clulllge
PerkNl
Below
0.5
Normal
0.5...!1.0 Hal/the ilonnal
1.0 - 1.3 One quarter ilonnal
The use of a fuel with a sulfur content above
1.3% is not
recommended.
Ford
M2Cl34-D/C
Ford
M2C134-D/C
Ford
M2C134-D/C
Ford
M1C75-NB
orM1C137-B
Ford
M2C134-D/C
Ford
M2C134-D
only
Ford
M2C134-D/C
NOTE:
The
tires
fitted
to
tractors
with optionalfourwheel drive have been carefullyse"cted
to111111Ch
the
gearing of
the
transmission
and
axles.
When
renewing
worn
or damaged tires, always install tires of the
same
make, model and size
as
those
removed.
The
installation of other
tire
combinations may result in
excessive tire
wear,
loss
of useable power or
severe
damage
to
drive line
componelllS.
l/in
doubt,
consult
your
Ford
New
Holland
dealer.
See
the
following pages for tire pressure and
load
tables.
10
w•
To Next Page
Loading...
Need help?
General
