--------------SECTION
A
16.Left-Had
Lift
Rod
1.
Grease
fining
3. Securing pin
2.
Lower
end of lift rod
Lift
Rods
To
adjust the left-hand lift rod. remove the secur-
ing pin (Figure
16)
and turn the lower half
of
the
lift rod to
lengthen
or
shorten
the
lift
rod
assem-
bly,,
as
required.
Ensure
the
grease
filling remains
facing
rearward.
A WARNING: Before disconnecting a lift
4la
rod
from the lower link, stop the engine.
lower
attached equipment to the ground
and
en-
sure
the
hydraulic
lift control lever is fully for-
ward. Ensure attached equipment is correctly
suppDl"ted
and
that
no
residual pressure remains
in
the,
hydraulic system before removing the lift
rod
securing pin.
For nonnal operation the left-hand Ii fl
rod
should
be
adjusted
so
the length between centers of
the
fixing points is 30.4 (770
mm).
The
right-hand lift rod is adjusted
by
means of a
hand
wheel attached to the levelling box. Sec Fig-
ure
17.
Lift
the
locking latch
in
order
to
tum
the
hand
wheel.
Tum
the crank handle or hand
wheel
clockwise
to
shoncn the lift rod. Turn counter-clockwise to
lengthen
the
lift rod. When
the
lift
rod
is
correctly
17.Right-Hand Lift Rod
1.
Hand wheel
2. Locking latch
set, push the latch down
to
prevent further rotation
of
the hand wheel.
NOTE:
Both left
and
right-hand lift rods may
have a slot
as
well as a round hole
at
the lower
end.
If
the
pivot
bolt
or
pin
is inserted through the
slotted hole this will allow
an
implement limited
vertical movement independent
of
the tractor
which is a
usefulfeaturefor
the operation
of
wide
implements. When the pivot bolt is inserted
through the slotted hole, avoid overtightening the
locknut to prevent the lift rod being pinched.
Each lower link
has two holes
for
attachment
of
the lift rods. Attach the lift rods to the front
lwLes
(nearest the tractor)
for
maximum lift height. Use
the rear holes
for
normal operation
and
maximum
lift capacity.
Top
Link
The
top link length is adjusted
by
turning
the
sleeve. Sec Figure 18. The latch must
be
pulled
back
bcf
ore
the
sleeve can
be
turned. Most equip-
ment
will operate at
the
correct depth/height
if
Lhc
lop link is set to a nominal 27 in. (685 mm)
mca.41i-
ured between the centers of the attaching
pins.
When transponing the tractor, hook the link plate
over
the
lug on the hydraulic lift rocker.
17
To Next Page
Loading...
Need help?
General
