6.6 Messages
6-24
6.6.2 Message on NBDP terminal
CONNECTING
The line is connected.
Channel Busy Check. To forcibly transmit a call, press the ENTER key.
This message appears during channel busy check before a call. If the channel is not used,
press [Enter] to start calling.
Check interconnections between terminal and Main.
No communication between the control unit and the terminal unit is made for more than 30
seconds. Check the connection.
Cannot print. Check interconnections between printer and terminal.
The printer is not ready. Check the printer connection, the paper, and the printer setting,
“ON LINE”.
Check interconnections between radio and Main.
RT fails to communicate with NBDP DSP.
Check interconnections between DSC and Main.
RT fails to communicate with DSC DSP.
CALLING FAILED.
The line is not connected in ARQ mode after 128 time calls (about one minute).
Station calling suspended. Check radio and interconnections.
A recall is made on the same frequency within one minute. Wait for 1 minute or more for
recalling.
unknown unit
The terminal unit detects no connection of FS-1570 or FS-2570.
Write protect error
Floppy Disk is write-protected.
Drive not ready.
A floppy disk is not inserted into the floppy disk drive.
To Next Page
Loading...
Need help?
General
