7.1 Output power
7-4
7.1.3 Adjustment of output power for operating frequency
To adjust output power for operating frequency;
1. With RT display, press [SETUP] to show Setup menu.
2. Move the cursor over SYSTEM and press [ENT]. System setup menu protected
appears.
3. Enter the password, xxxxxx.
4. Select TX POWER (FREQ) by using the cursor.
5. Press [ENT] to show Tx Power setupt menu.
Table 7.1.3 Tx Power setup (FREQ) menu
6. Select TX MODE and press [ENT]. Then, select emission mode, followed by
[ENT].
7. Select TX FREQUENCY and press [ENT]. Then, enter operating frequency,
followed by [ENT].
8. Set TX POWER line. (HIGH, MID or LOW)
Item Description Options
TX MODE Selects emission mode SSB, TLX (DSC)
TX FREQUENCY Selects operating frequency
TX POWER Selects output power LOW, MID, HIGH
TX POWER ADJ Sets power data 0 to 255
TX POWER TUNE Sets tuning power 0 to 140
SAVE TX POWER Saves above data
ERASE
TX POWER
Selects factory default
HIGH: 240,
MID: 210(FS-1570), 180(FS-2570)
LOW: 195 (1570); 160 (2570)
TUNE: 90
To Next Page
Loading...
Need help?
General
