GE Power Quality Meter Series User Manual

5-22 PQM Power Quality Meter GE Power Management
5.3 A2 STATUS 5 MONITORING
5
Figure 5–13: ACTUAL VALUES PAGE 2 – STATUS / ALARMS
The alarm messages appear only when the alarm threshold has been exceeded for the programmed time.
When an alarm is assigned to an output relay, the relay can be set to be unlatched or latched. When the alarm
is set as unlatched, it automatically resets when the alarm condition no longer exists. If the alarm is set as
latched, a keypad reset or a serial port reset is required.
The
SELF TEST ALARM
occurs if a fault in the PQM hardware is detected. This alarm is permanently
assigned to the alarm output relay and is not user configurable. If this alarm is present, contact the
GE Power Management Service Department.
5.3.2 SWITCH STATUS
Figure 5–14: ACTUAL VALUES PAGE 2 – SWITCH STATUS
SWITCH INPUT A/B/C/D STATE
: To assist in troubleshooting, the state of each switch can be verified using
these messages. A separate message displays the status of each input identified by the corresponding name
as shown in the wiring diagrams in chapter 2. For a dry contact closure across the corresponding switch termi-
nals the message will read
CLOSED
.
PULSE INPUT 1
ALARM
PULSE INPUT 2
ALARM
PULSE INPUT 3
ALARM
PULSE INPUT 4
ALARM
TOTALIZED PULSES
ALARM
TIME
ALARM
MESSAGE
MESSAGE
CONTINUED FROM
PREVIOUS PAGE
NOTE
]] ACTUAL VALUES
]] A2 STATUS
] SWITCHES
]
SWITCH INPUT A
STATE: CLOSED
SWITCH INPUT B
STATE: CLOSED
SWITCH INPUT C
STATE: CLOSED
SWITCH INPUT D
STATE: CLOSED
]] ACTUAL VALUES
]] A3 POWER ANALYSIS
ACTUAL
MESSAGE
MESSAGE
MESSAGE

GE Power Quality Meter Series Specifications

General

Brand	GE
Model	Power Quality Meter Series
Category	Measuring Instruments
Language	English