GE Power Quality Meter Series User Manual

4-8 PQM Power Quality Meter GE Power Management
4.2 S1 PQM SETUP 4 PROGRAMMING
4
4.2.6 CLOCK
Figure 4–6: SETPOINTS PAGE 1 – PQM SETUP / CLOCK
•
SET TIME/DATE:
These messages are used to set the time and date for the PQM software clock.
The PQM software clock retains an accurate time for power interruptions lasting up to one hour. A
CLOCK NOT
SET
alarm can be enabled so that an alarm will occur on the loss of clock data. The time and date are used for
all time-stamped data. If the clock has not been set, a
?
will appear on the right-hand side of the displayed time
for all time-stamped data. Follow the steps shown below to set the new time and date.
]] SETPOINTS
]] S1 PQM SETUP
] CLOCK
]
SET TIME hh:mm:ss
12:00:00 am DATE->
SET DATE mm:dd:yyyy
Jan 01, 1996
]] SETPOINTS
]] S2 SYSTEM SETUP
SETPOINT
] PREFERENCES
]
] FRONT PANEL RS232
] SERIAL PORT
] DNP 3.0
] CONFIGURATION
MESSAGE
MESSAGE
MESSAGE
MESSAGE
MESSAGE
SET TIME hh:mm:ss
12:00:00 am DATE->
SET TIME hh:mm:ss
03:00:00 am DATE->
SET TIME hh:mm:ss
03:35:00 am DATE->
MESSAGE
SET TIME hh:mm:ss
03:35:55 am DATE->
NEW TIME
HAS BEEN STORED
SET DATE mm:dd:yyyy
Jan
01, 1996
SET DATE mm:dd:yyyy
Oct 01, 1996
SET DATE mm:dd:yyyy
Jan 01, 1997
NEW DATE
HAS BEEN STORED
MESSAGE
MESSAGE
STORE
MESSAGE
MESSAGE
STORE
MESSAGE
VALUE
USE THE VALUE
KEYS TO SELECT
THE UNDERLINED
QUANTITIES

GE Power Quality Meter Series Specifications

General

Brand	GE
Model	Power Quality Meter Series
Category	Measuring Instruments
Language	English