GE Power Quality Meter Series User Manual

4-34 PQM Power Quality Meter GE Power Management
4.4 S3 OUTPUT RELAYS 4 PROGRAMMING
4
4.4 S3 OUTPUT RELAYS 4.4.1 DESCRIPTION
Figure 4–21: SETPOINTS PAGE 3 – OUTPUT RELAYS
]] SETPOINTS
]] S3 OUTPUT RELAYS
]] SETPOINTS
]] S4 ALARMS/CONTROL
SETPOINT
ALARM OPERATION:
NON-FAILSAFE
ALARM ACTIVATION:
UNLATCHED
AUX1 OPERATION:
NON-FAILSAFE
AUX2 ACTIVATION:
UNLATCHED
AUX2 OPERATION:
NON-FAILSAFE
AUX2 ACTIVATION:
UNLATCHED
] ALARM RELAY
]
] AUXILIARY RELAY 1
]
] AUXILIARY RELAY 2
]
AUX3 OPERATION:
NON-FAILSAFE
AUX3 ACTIVATION:
UNLATCHED
] AUXILIARY RELAY 3
]
] END OF PAGE S3
]
NON-FAILSAFE:
The relay coil is not energized in its non-active state. Loss of control power will cause the
relay to remain in the non-active state. That is, a non-failsafe alarm relay will not cause an
alarm on loss of control power. Contact configuration in the Wiring Diagrams is shown with
relays programmed non-failsafe and control power not applied.
FAILSAFE:
The relay coil is energized in its non-active state. Loss of control power will cause the relay
to go into its active state. That is, a failsafe alarm relay will cause an alarm on loss of
control power. Contact configuration is opposite to that shown in the Wiring Diagrams for
relays programmed as failsafe when control power is applied.
Range: NON-FAILSAFE, FAILSAFE
Range: UNLATCHED, LATCHED
Range: NON-FAILSAFE, FAILSAFE
Range: UNLATCHED, LATCHED
Range: NON-FAILSAFE, FAILSAFE
Range: UNLATCHED, LATCHED
Range: NON-FAILSAFE, FAILSAFE
Range: UNLATCHED, LATCHED
MESSAGE
MESSAGE
MESSAGE
MESSAGE
MESSAGE
MESSAGE
MESSAGE
MESSAGE
MESSAGE
MESSAGE
MESSAGE
MESSAGE
MESSAGE
MESSAGE

GE Power Quality Meter Series Specifications

General

Brand	GE
Model	Power Quality Meter Series
Category	Measuring Instruments
Language	English