GE Power Quality Meter Series User Manual

GE Power Management PQM Power Quality Meter 9-1
9 COMMISSIONING 9.1 COMMISSIONING
9
9 COMMISSIONING 9.1 COMMISSIONING
Table 9–1: PQM SETPOINTS (Sheet 1 of 11)
S1 PQM SETUP
PREFERENCES
DEFAULT MESSAGE TIME min.
DEFAULT MESSAGE BRIGHTNESS %
DISPLAY FILTER CONSTANT
SETPOINT ACCESS
SETPOINT ACCESS
ENTER SETPOINT ACCESS CODE
SETPOINT ACCESS ON FOR min.
CHANGE ACCESS CODE
ENTER NEW ACCESS CODE
RE-ENTER NEW ACCESS CODE
ENCRYPTED ACCESS CODE
COM 1 RS485 PORT
MODBUS COMM ADDRESS
COM 1 BAUD RATE baud
COM 1 PARITY
COM 2 RS485 PORT
COM 2 BAUD RATE baud
COM 2 PARITY
FRONT PANEL RS232 PORT
RS232 BAUD RATE baud
RS232 PARITY
DNP 3.0 CONFIGURATION
DNP PORT
DNP SLAVE ADDRESS
DNP TURNAROUND TIME ms
CLOCK
SET TIME hh:mm:ss
SET TIME mm:dd:yyyy
CALCULATION PARAMETERS
EXTRACT FUNDAMENTAL
CURRENT DEMAND TYPE
CURRENT DEMAND TIME INTERVAL min.
POWER DEMAND TYPE
POWER DEMAND TIME INTERVAL min.
S1 PQM SETUP continued
ENERGY COST PER kWh cents
TARIFF PERIOD 1 START TIME min.
TARIFF PERIOD 1 COST PER kWh cents
TARIFF PERIOD 2 START TIME min.
TARIFF PERIOD 2 COST PER kWh cents
TARIFF PERIOD 3 START TIME min.
TARIFF PERIOD 3 COST PER kWh cents
EVENT RECORDER
EVENT RECORDER OPERATION
TRACE MEMORY
TRACE MEMORY USAGE cycles
TRACE MEMORY TRIGGER MODE
Ia OVERCURRENT TRIG LEVEL % CT
Ib OVERCURRENT TRIG LEVEL % CT
Ic OVERCURRENT TRIG LEVEL % CT
In OVERCURRENT TRIG LEVEL % CT
Va OVERVOLTAGE TRIG LEVEL % nominal
Vb OVERVOLTAGE TRIG LEVEL % nominal
Vc OVERVOLTAGE TRIG LEVEL % nominal
Va UNDERVOLTAGE TRIG LEVEL % nominal
Vb UNDERVOLTAGE TRIG LEVEL % nominal
Vc UNDERVOLTAGE TRIG LEVEL % nominal
SWITCH INPUT A TRIG
SWITCH INPUT B TRIG
SWITCH INPUT C TRIG
SWITCH INPUT D TRIG
TRACE MEMORY TRIGGER DELAY cycles
TRACE MEMORY TRIGGER RELAY
PROGRAMMABLE MESSAGE
PROGRAMMABLE MESSAGE NAME
Table 9–1: PQM SETPOINTS (Sheet 2 of 11)

GE Power Quality Meter Series Specifications

General

Brand	GE
Model	Power Quality Meter Series
Category	Measuring Instruments
Language	English