GE Power Quality Meter Series User Manual

3-6 PQM Power Quality Meter GE Power Management
3.3 KEYPAD 3 OPERATION
3
3.3.6 MESSAGE KEYS
To move between message groups within a page use the and keys. The
key moves toward the end of the page and the key moves toward the beginning of
the page. A page header message will appear at the beginning of each page and a page footer message will
appear at the end of each page. To select messages within a subgroup press . To back out of the
subgroup, press to access the previous message or to go to the next subgroup.
Figure 3–5: MESSAGE KEY OPERATION
3.3.7 VALUE KEYS
Setpoint values are entered using the and keys. When a setpoint is displayed calling for
a yes/no response, each time or is pressed, the "Yes" becomes a "No," or the "No"
becomes a "Yes." Similarly, for multiple choice selections, each time or is pressed, the
next choice is displayed. When numeric values are displayed, each time is pressed, the value
increases by the step increment, up to the maximum. Hold the key down to rapidly change the value.
MESSAGE
MESSAGE
MESSAGE
MESSAGE
MESSAGE
MESSAGE
MESSAGE
]] SETPOINTS
]] S1 PQM SETUP
] PREFERENCES
]
] COM1 RS485
] SERIAL PORT
DEFAULT MESSAGE TIME
1.0 MINUTES
DEFAULT MESSAGE
BRIGHTNESS: 60%
MESSAGE ▲
MESSAGE ▼
SETPOINT
MESSAGE4
MESSAGE3
]] SETPOINTS
]] S2 SYSTEM SETUP
SETPOINT
MODBUS COMMUNICATION
ADDRESS: 1
COM1 BAUD RATE:
9600 BAUD
MESSAGE4
MESSAGE3
COM 1 PARITY: NONE
MESSAGE ▲
MESSAGE ▼
MESSAGE ▲
MESSAGE ▼
M
E
S
S
A
G
E
MOVES FORWARD
WITHIN SUBGROUP
MOVES BACK
WITHIN SUBGROUP
MOVES
TO NEXT
SUBGROUP
MOVES TO
PREVIOUS
SUBGROUP
MESSAGE
MSGKEYOP.VSD
VALUE VALUE
VALUE VALUE
VALUE
VALUE
VALUE

GE Power Quality Meter Series Specifications

General

Brand	GE
Model	Power Quality Meter Series
Category	Measuring Instruments
Language	English