HEIDENHAIN ITNC 530 User Manual

TNC model, software and features
HEIDENHAIN iTNC 530 11
Intended place of operation
The TNC complies with the limits for a Class A device in accordance
with the specifications in EN 55022, and is intended for use primarily
in industrially-zoned areas.
Legal information
This product uses open source software. Further information is
available on the control under
 Programming and Editing operating mode
 MOD function
 LEGAL INFORMATION SOFT KEY
smarT.NC: Positioning strategy for
machining point patterns
smarT.NC Pilot
FCL 2 functions Description
3-D line graphics Page 162
Virtual tool axis Page 622
USB block devices supported (memory
sticks, hard disks, CD-ROM drives)
Page 141
Filtering of externally created contours Page 455
Possibility of assigning different depths
to each subcontour in the contour
formula
User’s Manual for
Cycles
Touch-probe cycle for global setting of
touch-probe parameters
Touch Probe Cycles
User's Manual
smarT.NC: Graphic support of block
scan
smarT.NC Pilot
smarT.NC: Coordinate transformation smarT.NC Pilot
smarT.NC: PLANE function smarT.NC Pilot
FCL 3 functions Description

HEIDENHAIN ITNC 530 Specifications

General

Brand	HEIDENHAIN
Model	ITNC 530
Category	Control Systems
Language	English