HEIDENHAIN ITNC 530 User Manual

HEIDENHAIN iTNC 530 473
11.14 Working with cutting data tables
Working with automatic speed / feed rate
calculation
1 If it has not already been entered, enter the type of workpiece
material in the file WMAT.TAB
2 If it has not already been entered, enter the type of cutting material
in the file TMAT.TAB
3 If not already entered, enter all of the required tool-specific data in
the tool table:
 Tool radius
 Number of teeth
 Tool type
 Tool material
 The cutting data table for each tool
4 If not already entered, enter the cutting data in any cutting data
table (CDT file).
5 Test Run operating mode: Activate the tool table from which the
TNC is to take the tool-specific data (status S).
6 In the NC program, set the workpiece material by pressing the
WMAT soft key
7 In the NC program, let the TOOL CALL block automatically calculate
the spindle speed and feed rate via soft key

HEIDENHAIN ITNC 530 Specifications

General

Brand	HEIDENHAIN
Model	ITNC 530
Category	Control Systems
Language	English