76 First Steps with the iTNC 530
1.7 Running the first program
1.7 Running the first program
Selecting the correct operating mode
You can run programs either in the Single Block or the Full Sequence
mode:
Press the operating mode key: The TNC goes into the
Program Run, Single Block mode and the TNC
executes the program block by block. You have to
confirm each block with the NC start key
Press the Program Run, Full Sequence operating
mode key: The TNC switches to that mode and runs
the program after NC start up to a program
interruption or to the end of the program
Further information on this topic
Operating modes of the TNC: See "Operating modes", page 82
Running programs: See "Program Run", page 647
Choosing the program you want to run
Press the PGM MGT key: The TNC opens the file
manager
Press the LAST FILES soft key: The TNC opens a pop-
up window with the most recently selected files
If desired, use the arrow keys to select the program
that you want to run. Load with the ENT key
Further information on this topic
File management: See "Working with the file manager", page 124
Start the program
Press the NC start key: The TNC runs the active
program
Further information on this topic
Running programs: See "Program Run", page 647
To Next Page
Loading...
Need help?
General
