460 Programming: Special Functions
11.11 Defining coordinate transformations
Defining a program call
Using the program selection functions you can select any NC program
with the SEL PGM function and call it later with CALL SELECTED PGM. The
SEL PGM function is also permitted with string parameters, so that you
can dynamically control program calls.
Define the program to be called
Show the soft-key row with special functions
Select the menu for defining various plain-language
functions
Select the menu for functions for defining the
program selection
Select the SEL PGM function: enter path names directly
or select the program via the SELECTION WINDOW
soft key. To enter a string parameter you press the Q
key and then enter the string number
Calling a selected program
Show the soft-key row with special functions
Select the menu for defining various plain-language
functions
Select the menu for functions for defining the
program selection
Select the CALL SELECTED PGM function: enter path
names directly or select the program via the
SELECTION WINDOW soft key. To enter a string
parameter you press the Q key and then enter the
string number
Beispiel: NC blocks
13 SEL PGM “ROT34.H“
14 ...
33 CALL SELECTED PGM
34 ...
66 SEL PGM QS35
65 CALL SELECTED PGM
If you have selected a datum table in the TRANS DATUM
TABLE block, then the TNC uses the programmed line
number only until the next call of a datum number
(blockwise effective datum shift).
If you did not define a table in the TRANS DATUM TABLE
block, then the TNC uses the datum table already selected
in the NC program with SEL TABLE or the datum table with
status M selected in one of the Program Run modes.
To Next Page
Loading...
Need help?
General
