• Execute operation ([alt]+t) for refreshing screen when following
phenomenon occurred.
– Previous display remains on the screen.
– A part of display lacks on the screen.
– A cursor cannot move by pressing arrow keys though selectable items
exist on the screen.
– A cursor is not displayed though selectable items exist on the screen.
• LPAR manager screen might be switched when any arrow key or any
function key is consecutively pressed. Re-display a target screen if this
phenomenon occurred.
• LPAR manager screen cannot be operated for one or two minutes while a
lot of LPARs are being activated or deactivated by operating SC/BSM.
Common items for all screens
Common items for all screens are below.
Figure 7-1 LPAR manager Status on the LPAR manager Screen
Table 7-3 Description of Error Event Detection
No. Item Description
Default
Value
Supported LPAR
manager
Version
(1) Error Event
Detected
It indicates that error was
detected in LP System Logs.
Please confirm the LP System
Logs on the LP system logs
screen when this item is
displayed.
This item disappears on the
screen by pressing Esc key or
opening LP system logs screen
again.
- 01-0X~
(2) Safe Mode It indicates that LPAR manager
started in the safe mode.
For details, see Safe mode on
page 4-17
- 02-2X~
LPAR manager Menu
LPAR manager Menu screen is below.
7-6
Operation by LPAR manager Screen
Hitachi Compute Blade 500 Series Logical partitioning manager User's Guide
To Next Page
Loading...
Need help?
General