• If you operate the mouse on the EFI screen or text screen during the
guest OS installation, input from the keyboard may slow down. Do not
use the mouse on those screens.
• There is possibility that the error message is not displayed during
Windows boot up. In that case, check a guest screen or a virtual COM
console.
NETM/Remote Control
When you use the remote control function, the screen display and mouse
operation slow down due to SVGA emulation.
When you need not assign USB, use the remote control function while USB
device/remote control are not assigned.
However, the performance of remote control function improved only following
condition.
Table 10-13 Available Display Size for Remote Console
Video Mode Display Size
Assigned USB Device/Remote
control to LPAR
Yes No
Text Mode N/A - -
Graphic Mode 640x480 - -
800x600 - -
1024x768 - Y
1280x1024 - -
Other - -
Legend:
Y: Improved
-: Not Improved
Server Conductor/Blade Server Manager
Not supported for displaying/setting of VF NIC.
Do not backup configuration information using SC/BSM while the
configuration is being saved on the LPAR manager screen or HVM Navigator,
or LPAR migration is being performed. If you do, backed up configuration is
incomplete. Discard the back-up obtained during the saving or migration
mentioned lower. Back up the configuration again after the save or the
migration is complete.
Notes
10-21
Hitachi Compute Blade 500 Series Logical partitioning manager User's Guide
To Next Page
Loading...
Need help?
General