Hitachi CB 520H B2 User Manual

Transfer to Basic environment from LPAR manager environment
The following table shows the setting and checking items when LPAR
manager environment is transferred to Basic environment.
Table 2-9 Setting/checking item
Item
Setting/checking item
Before transfer After transfer
Guest OS IP address deletion (only for
windows)
IP address setting
(only for windows)
- Driver installation
- Teaming/Bonding
configuration
Server blade
EFI setting
1
-
Basic mode setting
1
-
Storage - WWPN/WWNN setting
Notes:
1. For details, see the Hitachi Compute Blade 500 series Server Blade Setup Guide.
IPv6 Setting for LP IP Addresses
You must set at least either an IPv4 address or an IPv6 address for LPAR
managers. Note that you can set both an IPv4 address and an IPv6 address
for LPAR managers.
• When you desire to allow an LPAR manager to communicate with the
management module in IPv6, you must set an IPv6 address for the LPAR
manager and the management module in advance.
• Set an LP IP address in an internet protocol in which you desire to allow
management server to communicate with LPAR managers. You can also
set two LP IP addresses in both IPv4 and IPv6 for an LPAR manager.
Firmware combinations
Server blade
Server blade
firmware
Management Module
firmware
LPAR manager
firmware
CB 520H B3 08-35 or later A0260 or later 02-25 or later
CB 520H B4 10-03 or later A0305 or later 02-50 or later
CB 520X B1 07-34 or later A0260 or later 02-25 or later
CB 520X B2 09-17 or later A0270 or later 02-27 or later
CB 520X B3 11-07 or later A0320 or later 02-56 or later
2-18
System Operation
Hitachi Compute Blade 500 Series Logical partitioning manager User's Guide

Hitachi CB 520H B2 Specifications

General

Brand	Hitachi
Model	CB 520H B2
Category	Server
Language	English