Honda BF90D User Manual

108
OPERATION
Tilt up the outboard motor using the
tilt lock lever when mooring the boat.
Move the shift lever or the remote
control lever to the NEUTRAL
position and stop the engine before
tilting up the outboard motor.
Before tilting up, leave the outboard
motor in the running position for one
minute after stopping the engine to
drain the water from inside the
engine.
1. Raise the outboard motor as full as
it goes using the power trim/tilt
switch.
2. Move the tilt lock lever to the
LOCK position and lower the
outboard motor until the lock lever
contacts the stern bracket.
3. Press the DN (down) of the power
trim/tilt switch and fully shorten
the trim rods.
4. To tilt down, raise the outboard
motor as far as it goes using the
power trim/tilt switch, move the tilt
lock lever to the FREE position.
TRIM RODS
Moorage (T type)
TILT LOCK LEVER TILT LOCK LEVER
FREE
LOCK
<;DQQMࡍ࡯ࠫ㧞㧜㧝㧟ᐕ㧝㧜᦬㧝㧤ᣣޓ㊄ᦐᣣޓඦᓟ㧞ᤨ㧟㧟ಽ

Honda BF90D Specifications

General

Bore & Stroke	73 mm x 89.4 mm
Horsepower	90 HP
Cooling System	Water Cooled
Starting System	Electric
Gear Ratio	2.33:1
Trim Range	-4° to +16°
Tilt Range	70°
Dry Weight	163 kg (359 lbs)
Lubrication	Wet Sump
Recommended Fuel	Unleaded Gasoline (86 Octane or higher)
Gear Shift	F-N-R
Steering	Remote
Trim Method	Power Trim and Tilt
Displacement	1496 cc
Exhaust	Through propeller
Alternator Output	44 Amps
Recommended Engine Oil	10W-30 FC-W
Shaft Length	20" or 25"
Engine Type	4-Stroke SOHC, 4 Cylinders
Fuel Delivery	Programmed Fuel Injection