FRU
Saves and restores the router’s configuration.
Admin session to restoreAuthority
restore
save
FRU
Syntax
The fru restore command requires that you first FTP the
tar file containing the configuration to the router. When
you issue this command, the system prompts you to enter
the restore level. You can fully restore the router’s configur-
ation (all configuration parameters and LUN mappings) or
restore only the LUN mappings. The restored configuration
does not take effect until the router is rebooted.
restore
Keywords
Creates a tar file containing the blade’s persistent data,
configuration, and LUN mappings. The file is stored in the
router’s /var/ftp directory. You must then FTP the tar
file from the router.
save
Example 1: The following is an example of the fru restore command:
MPX200 <1>(admin) #> fru restore
A list of attributes with formatting and current values will
follow. Enter a new value or simply press the ENTER key to accept
the current value. If you wish to terminate this process before
reaching the end of the list press 'q' or 'Q' and the ENTER key to
do so.
Type of restore (0=full, 1=mappings only) [full]
FRU restore completed.
Please reboot the system for configuration to take affect.
Example 2: The following is an example of the fru save command:
MPX200 <1>(admin) #> fru save
FRU save completed. Configuration File is QLogic_Router_FRU.bin
Please use FTP to extract the file out from the System.
Help
Displays a list of the commands and their syntax.
NoneAuthority
help
Syntax
Example 1: The help command differs for the chassis and the blade. The following example shows
the help command for the chassis:
MPX200 #>help
blade [1 | 2]
exit
help
history
MPX200 Multifunction Router 147
To Next Page
Loading...
Need help?
General