Thu Sep 10 13:15:49 2009
Seq id: 645 : Job Type: Migration : miguser :COMPLETED : JobId 0(Offline) of
group Group 0 with priority 0 from Target HP HSV200-0 Lun
60:05:08:b4:00:07:59:a4:00:02:a0:00:00:7e:00:00(6) to Target HP HSV200-0 Lun
60:05:08:b4:00:07:59:a4:00:02:a0:00:00:83:00:00(7) with migration size 5.00 GB
Thu Sep 10 13:33:16 2009
Seq id: 646 : Job Type: Migration : miguser :ACKNOWLEDGED : JobId 0(Offline)
of group Group 0 with priority 0 from Target HP HSV200-0 Lun
60:05:08:b4:00:07:59:a4:00:02:a0:00:00:7e:00:00(6) to Target HP HSV200-0 Lun
60:05:08:b4:00:07:59:a4:00:02:a0:00:00:83:00:00(7) with migration size 5.00 GB
Thu Sep 10 13:38:37 2009
Seq id: 647 : Job Type: Migration : miguser :ADDED : JobId 0(Offline) of group
Group 0 with priority 0 from Target HP HSV200-0 Lun Invalid Wwuln(6) to Target
HP HSV200-0 Lun Invalid Wwuln(7) with migration size 5.00 GB
Thu Sep 10 13:38:37 2009
Seq id: 648 : Job Type: Migration : miguser :STARTING MIGRATION : JobId
0(Offline) of group Group 0 with priority 0 from Target HP HSV200-0 Lun Invalid
Wwuln(6) to Target HP HSV200-0 Lun Invalid Wwuln(7) with migration size 5.00 GB
Thu Sep 10 13:39:45 2009
Seq id: 649 : Job Type: Migration : miguser :COMPLETED : JobId 0(Offline) of
group Group 0 with priority 0 from Target HP HSV200-0 Lun Invalid Wwuln(6) to
Target HP HSV200-0 Lun Invalid Wwuln(7) with migration size 5.00 GB
MPX200 (miguser) #>
Using the Verify Migration Job wizard
The Verify Migration Job wizard helps you configure verification jobs to compare data residing on
two LUNs. This ensures the data integrity of the migration process by performing a bit-by-bit comparison
of the data on the source LUN with the corresponding data on the destination LUN.
You can configure a verification job on a pair of source and destination LUNs only after the migration
job configured on that pair has been completed and acknowledged. The Verify Migration Job wizard
is generally the same as the Data Migration wizard (see “Using the Data Migration
Wizard” on page 263). All scheduling options and job state changes (start, stop, pause, and so on)
apply in the same way to both verification and migration jobs.
Starting the Verify Migration Job wizard
To start the Verify Migration Job wizard:
1. Start the iSCSI/FC Router Manager and connect to the MPX200 by providing the IP address of
the MPX200.
2. Start the Verify Migration Job wizard using one of these methods:
• From the Wizards menu, select Configure Verifying Jobs.
• In the left pane, open the Services page, and then right-click Configure Verifying Job.
3. In the Data Migration Security Check dialog box, enter your miguser password (the default is
migration), and then click OK.
Offline Data Migration286
To Next Page
Loading...
Need help?
General