To enable CHAP for the Microsoft iSCSI initiator:
1. Click Discovery.
• To discover iSCSI target portals manually:
a. Click Add under Target Portals.
b. Enter the IP address of the MPX200 iSCSI port.
c. Click Advanced.
d. Select the CHAP Login Information check box.
e. Enter the CHAP secret for the MPX200-discovered iSCSI initiator in the Target Secret box
(for example, CHAPsecret01).
f. Click OK.
The initiator completes target discovery.
• To use iSNS to discover iSCSI target portals:
a. Click Add under iSNS Servers.
b. Enter the IP address of the iSNS server.
c. Click OK.
2. Click Targets, and then select the appropriate target for login.
3. Click Log On.
4. Click Advanced.
5. Select the CHAP Login Information check box.
6. Enter the CHAP secret for the MPX200-discovered iSCSI initiator in the Target Secret box.
7. Click OK.
8. Click OK again.
The initiator completes normal login.
Enabling CHAP for the MPX200-discovered iSCSI initiator entry
You must use the CLI to enable CHAP for the MPX200-discovered iSCSI initiator entry:
• If the iSCSI initiator is not listed when you execute the set chap command, do one of the follow-
ing:
1. From HP Command View EVA, select Hosts, and then select the Add Host tab. Enter the IQN
string.
2. From the CLI, use the add command to add the iSCSI initiator that will perform the discovery.
• If the iSCSI initiator is listed when you execute the set chap command, then enable the CHAP
secret (for example, CHAPsecret01):
1. Select the index of the iSCSI initiator.
2. Enable CHAP by selecting 0 and then entering the CHAP secret.
Enabling CHAP for the Microsoft iSCSI initiator
To enable CHAP for the Microsoft iSCSI initiator:
MPX200 Multifunction Router 91
To Next Page
Loading...
Need help?
General