1. Open a miguser session using the following command:
miguser start -p migration
2. To view the status of migration license consumed and available on the current system, enter the
following command (see “show migration_usage” on page 336):
show migration_usage
The following example shows the show migration_usage command.
MPX200 (miguser) #> show migration_usage
Migration License Usage
-----------------------
Total capacity licensed 10240.00 GB
Migration license consumed 1.00 GB
License consumed by active jobs 10.00 GB
Total capacity available 10229.00 GB
Array Based Licenses
--------------------
Array based licences issued 3
Array based licences used 0
Available array based licenses 3
Command Line Interface
This section provides information on using the CLI for data migration services. It defines the guest
MPX200 account and the user sessions, admin and miguser. For each command, it provides a
description, the required session type, and an example.
User accounts
User accounts include the guest account. The guest account is the default user account used to log
into the MPX200 Telnet session. The guest session has a view-only type of access. The default password
for this account is password.
User sessions
User sessions include the admin session and miguser session, as described in the following.
Admin session
The admin is the system administrator session that provides access to CLI commands that manage the
system resources. The default password for starting the admin session is config. You can start and
stop an admin session using the following commands:
admin [start/begin]
admin [end/cancel/stop]
For example:
MPX200 #> admin start
Password : ******
MPX200 (admin) #>
MPX200 (admin) #> admin cancel
MPX200 #>
Offline Data Migration296
To Next Page
Loading...
Need help?
General