46
Connecting VCN or IVS1800 Cables
8.2
(1) Ground terminal (2) GE1 port (3) GE2 port (4) Power button (5) Power port
1. Connect one end of the ground cable to the grounding terminal of the device and the other
en
d to the grounding point of the network cabinet.
2. Connect one end of the network cable to any GE network port on the VCN510 or IVS1800.
3. Connect one end of the power cable to the power input port on the power module and the
other end to the rPDU in the cabinet.
Connecting a Monitoring Cable to the Smart ETH Gateway
8.3
(1) PWR_IN cascading
power port
(2) FE_1 cascading signal
port
(3) PoE_1–2 ports (4) PoE_3–4 ports
(5) 48V_OUT1 power
output port
(6) 48V_OUT2 power
output port
(7) FE_2 cascading
signal port
(8) PWR_OUT
cascading power port
(9) BLINK button (10) Status indicator
VCN510
IVS1800
To Next Page
Loading...
Need help?
General