IDEC FC4A-C16R2 User Manual

24: ANALOG I/O CONTROL
« FC4A MICROSMART USER’S MANUAL » 24-7
Analog I/O Control Parameters
Available parameters for analog I/O control depend on the type of analog I/O modules as summarized in the following
table. Designate the parameters in the Configure Parameters dialog box of the ANST macro as required by your applica-
tion.
Parameter
Analog I/O Module Analog Input Module Analog Output Module
END Refresh Type Ladder Refresh Type END Ladder
FC4A-
L03A1
FC4A-
L03AP1
FC4A-
J2A1
FC4A-
J4CN1
FC4A-
J8C1
FC4A-
J8AT1
FC4A-
K1A1
FC4A-
K2C1
Analog Input Signal Type
XXXXXX — —
Page 24-11 Page 24-11 —
Analog Input Data Type
XXXXXX — —
Page 24-11 Page 24-11 —
Analog Input Data
Minimum/Maximum Values
XXXXXX — —
Page 24-13 Page 24-13 —
Filter Value
———X X X — —
—— Page 24-13 —
Thermistor Parameter
————— X — —
——24-13 —
Analog Input Data
XXXXXX — —
Page 24-13 Page 24-13 —
Analog Input
Operating Status
XXXXXX — —
Page 24-13 Page 24-13 —
Analog Output Signal Type
XX———— X X
Page 24-15 — Page 24-15
Analog Output Data Type
XX———— X X
Page 24-15 — Page 24-15
Analog Output Data
Minimum/Maximum Values
XX———— X X
Page 24-15 — Page 24-15
Analog Output Data
XX———— X X
Page 24-15 — Page 24-15
Analog Output
Operating Status
XX———— X X
Page 24-15 — Page 24-15

IDEC FC4A-C16R2 Specifications

General

Brand	IDEC
Model	FC4A-C16R2
Category	Controller
Language	English