2. Check the length of the jump cable
and position another tractor near
the tractor with the discharged bat-
tery. Then, put all the shift levers
in the neutral position, apply the
parking brake, and stop the engine.
3. Wear protective glasses and glo-
ves and open the hoods of both
tractors. Remove the battery ter-
minal cover as necessary.
4. Connect the alligator clips on
both ends of the red positive
cable to the positive terminals of
both batteries.
5. Connect one clip of the black
negative cable to the negative
terminal of the normal battery
and the other clip to the tractor
body with the discharged battery.
Make sure to connect the clip to
the body part without paint.
6. Start the engine of the tractor
with the normal battery.
7. Start the engine of the tractor
with the discharged battery.
8. Disconnect the black cable from
the negative battery terminals of
both of the tractors.
9. Disconnect the red cable.
10. Run the engine for at least 30
minutes to charge the discharged
battery.
11. If the battery is discharged again,
replace it or check the charging
system, such as the alternator.
WARNING
Check if the seat is securely
locked after the seat adjust-
ment.
Do not adjust the seat while
driving. The seat may move
suddenly causing the loss of
control of the tractor.
•
•
(1) Seat
(2) Seat Adjustment Lever (Sliding)
TD2O505A
OPERATING THE TRACTOR
HOW TO DRIVE
1. Adjust the seat and fasten the seat
belt.
To Next Page
Loading...
Need help?
General
