The PTO selection switch is used
to switch between the automatic
operation and manual operation of
the PTO. The PTO switches can be
used as follows:
1. PTO automatic operation
When the PTO selection switch is
set in the automatic position, lifting
the hydraulic lift arm (or an imple-
ment) to given height automatically
disengages the PTO.
PTO SELECTION SWITCH (IF APPLICABLE)
(1) PTO Selection Switch
(A) Automatic (B) Manual
td2O414A
2. PTO manual operation
When the PTO selection switch
is set in the manual position, the
PTO is kept engaged regardless of
the lifting height of the lift arm (Im-
plement).
IMPORTANT
To avoid a shock applied to
the PTO shaft due to abrupt
operation, increase the engine
speed slowly after lowering
the engine speed and enga-
ging the PTO.
•
NOTE
The mark "
▲
" on the speedo-
meter in the instrument cluster
indicates 540 rpm of the PTO.
•
To Next Page
Loading...
Need help?
General
