1. Disengage the P.T.O, lower all
implements, place all control le-
vers in the neutral position, set
the parking brake, stop the engine
and remove the key.
WHEN PARKING THE TRACTOR
T66O120a
(1) P.T.O Shaft Cover (2) P.T.O Shaft Cap
WHEN OPERATING THE P.T.O
1. Make sure the tractor is completely
stopped, gears are in neutral and
all moving components have com-
pletely stopped before connecting,
disconnecting, adjusting, clean-
ing or servicing any P.T.O driven
equipment.
2. Keep the P.T.O shaft cover in place
at all times. Replace the P.T.O
shaft cap when the shaft is not in
use.
H23O121a
3. Before installing or using P.T.O
driven equipment, read the man-
ufacturer's manual and review the
safety labels attached to the equip-
ment.
WARNING
Before driving an implement
through the PTO, always make
sure that all bystanders are
well away from the tractor.
When using the PTO drive with
a stationary tractor, always
make sure that the gears are
in neutral and that the parking
brake is applied.
Before starting up any PTO-
driven implement hitched to
the three-point linkage, lift the
implement to its full height
and check that at least 1/4 of
the total length of the telesco-
pic section of the drive shaft
is engaged.
•
•
•
To Next Page
Loading...
Need help?
General
