8
-
4
DK4810/5310/5810(HS)
1. Check the tire air pressure and in-
atethetiresiftheyarelow.
2. Install the battery. Check that the
battery is fully charged before in-
stalling it.
3. Check the fan belt tension.
4.Check all uid levels. (Engine oil,
transmission/hydraulic oil, and en-
gine coolant)
5. Remove grease from the exposed
cylinder rod.
6. Apply grease to the lubrication
points.
7. Depress the clutch pedal and undo
the latch hook.
8. Get onto the tractor and start the
engine.
9. Check if the instrument panel and
all parts operate correctly while run-
ning the engine for a few minutes.
USING TRACTOR AFTER LONGTERM STORAGE
10. Drive the tractor outside and che-
ck if it is operating properly. Park
the tractor outside and idle engine
for at least 5 minutes. Stop the
engine and visually inspect the
tractor. Check if there is leakage.
11. Start the engine, release the
parking brake and depress the
brake pedal to check for its pro-
per condition. Adjust the free play
of the brake pedal if necessary.
12. Stop the engine and check for
leakage. Repair any part as re-
quired.
USAGE AND DISPOSAL
In order to protect the environment,
use and dispose of the tractor kee-
ping the following in mind:
1. When changing the oil or coolant
by yourself, be careful not to spill it
and dispose used oil and coolant
properly according to the applica-
ble regulations.
2. Never leave or discard the expired
tractor or implement, but contact
your local KIOTI Dealer to dispose
it according to the regulations.
3. Avoid working under high load as it
can cause excessive exhaust gas,
which is harmful to the environ-
ment.
To Next Page
Loading...
